Does TI suppport a Ultra ATA/100 PCI Card?

Discussion in 'Acronis True Image Product Line' started by Fusion, Jan 20, 2005.

Thread Status:
Not open for further replies.
  1. Fusion

    Fusion Registered Member

    Joined:
    Jan 13, 2005
    Posts:
    10
    My hard drives are hooked up to a Ultra ATA/100 PCI Adapter Card. Will I be able to make an image of drive C onto drive D through this adapter card? The manufacturer of this adpater card is Maxtor.
     
  2. bobbyjak

    bobbyjak Registered Member

    Joined:
    Dec 17, 2004
    Posts:
    35
    I have that setup and TI works just fine with it..
     
  3. Acronis Support

    Acronis Support Acronis Support Staff

    Joined:
    Apr 28, 2004
    Posts:
    25,885
  4. Fusion

    Fusion Registered Member

    Joined:
    Jan 13, 2005
    Posts:
    10
    Are you using the driver provided by the manufacturer or the one that was installed with Windows?
     
  5. bobbyjak

    bobbyjak Registered Member

    Joined:
    Dec 17, 2004
    Posts:
    35
    The manufacturer..
     
  6. Fusion

    Fusion Registered Member

    Joined:
    Jan 13, 2005
    Posts:
    10
    I see. Maybe that's what my problem is. I just did a fresh XP install not too long ago and windows did all the driver installation. But from what I read I need to attach my drives to the motherboard and install them before connecting the adapter card. I don't think I can upgrade them now when in use.
     
  7. bobbyjak

    bobbyjak Registered Member

    Joined:
    Dec 17, 2004
    Posts:
    35
    The normal procedure is:
    1. Install card with NO drives attached.
    2. Boot into windows & install driver for controller card.
    3. Power down PC, attach drives to controller card.
    4. Re-boot into windows & you should be up & flying.
     
Thread Status:
Not open for further replies.