Total scan

Discussion in 'NOD32 version 2 Forum' started by orthoseeker, May 8, 2004.

Thread Status:
Not open for further replies.
  1. orthoseeker

    orthoseeker Registered Member

    Joined:
    May 8, 2004
    Posts:
    5
    Is it possible to scan EVERY file on your HDs using NOD32?
    If so, HOW? o_O
     
  2. Dazed_and_Confused

    Dazed_and_Confused Registered Member

    Joined:
    Mar 4, 2004
    Posts:
    1,831
    Location:
    USA
    Welcome Orthoseeker -

    Did you try clicking on "Resident Modules and Filters" > "NOD32", and then "Run NOD32"? From there you can selec the drives to scan. You can go into the "Extension Editor" to add file types, or check the box to "Scan All Files".
     
  3. orthoseeker

    orthoseeker Registered Member

    Joined:
    May 8, 2004
    Posts:
    5
    I did. I ran the on-demand scanner (NOD32), and set it to scan all files. However, when the file scanning was finished, the report window said that only 20,000-30,000 files were scanned, out of a hundred thousand on two volumes.
     
  4. Dazed_and_Confused

    Dazed_and_Confused Registered Member

    Joined:
    Mar 4, 2004
    Posts:
    1,831
    Location:
    USA
    Orthoseeker,

    If you had all drives selected to scan, not sure what the problem might be.:doubt:
     
Thread Status:
Not open for further replies.