snap deployment stops after 40%

Discussion in 'Other Acronis Products' started by LSch, Mar 24, 2008.

Thread Status:
Not open for further replies.
  1. LSch

    LSch Registered Member

    Joined:
    Mar 24, 2008
    Posts:
    1
    I'm using a trial version of acronis snap deployment. after using a boot cd to start the agent I'm able to start the deployment of the image. unfortunately, after exactlty 40% the agent stops the deployment and restarts the system.

    the image is saved on the same computer where I use the management control. no error appears...

    does anyone has a solution?

    thanks
     
    LSch, Mar 24, 2008
    #1
  2. chadeldridge

    chadeldridge Registered Member

    Joined:
    Mar 25, 2008
    Posts:
    6
    try to change to unicast and not multicast.

    Or are you saying the image is on the same computer that you are trying to image from?
     
    chadeldridge, Mar 25, 2008
    #2
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...