SiL 3114r SATA (non-RAID) and Security Zone

Discussion in 'Acronis True Image Product Line' started by Trev C, Nov 25, 2005.

Thread Status:
Not open for further replies.
  1. Trev C

    Trev C Registered Member

    Nov 24, 2005
    I have spent many hours trying to get this to work.

    I am using TI9 Build 2302 and would appreciate any pointers.

    I can create a Security Zone on the non-boot SATA drive connected to SiL3114r but can't activate.

    "Error - The hard disk you have selected is not available when booting your PC and you will be able to restore data from Acronis Secure Zone located on this drive only from Windows"

    Running Windows XP SP2++ and SiL3114r driver v1.0.0.7
  2. Menorcaman

    Menorcaman Retired Moderator

    Aug 19, 2004
    Menorca (Balearic Islands) Spain
    Hello Trev,

    This is the same error message you get if you attempt to active the Startup Recovery Manager (SRM) for a Secure Zone that's been created on a removable drive. You should be able to ignore the error message by clicking "OK" and proceed with activating the SRM.

    When done, boot into the Linux based rescue environtment via the SRM (press F11 whilst booting). With a bit of luck, TI will successfully detect the SATA drive in question.

Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.