Setup for TDS-3

Discussion in 'ProcessGuard' started by cjtc, Apr 19, 2004.

Thread Status:
Not open for further replies.
  1. cjtc

    cjtc Registered Member

    Joined:
    Apr 16, 2004
    Posts:
    22
    Location:
    Swindon, UK
    Another newbie to PG (so far, so good :) )

    Can anyone tell me the suggested protection settings for TDS-3 (with execution security enabled) ?

    TIA
     
  2. Pilli

    Pilli Registered Member

    Joined:
    Feb 13, 2002
    Posts:
    6,217
    Location:
    Hampshire UK
    Hi Cjtc & welcome, Peronally I just add tds-3.exe with the standard blocks, no allows and Close Meassge Handling enabled. Some of the utilities will require you to enter a human interface password to close, so if you are using these a lot then you may want to add them to the protected list.
    When you do an update the checksum protection may kick in when an .exe is changed but this is no real problem.

    HTH Pilli
     
Thread Status:
Not open for further replies.