Scanner - log?

Discussion in 'NOD32 version 2 Forum' started by SG1, Jan 27, 2008.

Thread Status:
Not open for further replies.
  1. SG1

    SG1 Registered Member

    Jan 16, 2003
    I ran the scanner, set to scan only; looked at log and it claims to have found two threats. Ah, perhaps I missed a setting somewhere, but I should glance through thousands of lines about each file scanned to see what/where, the alleged threat is?

    Again, perhaps I missed a setting, but ALL programs should end scan-log with summation of what/where the problem lies.

    A backup program that I have, for instance, allows the short or verbose command on end results; can't recall if for example TrojanHunter went to similar end result tab.

    The summary page or a line or two about results, is my opinion on things; your mileage may vary. ;-)

    * Am still using ver 2.7 of NOD32.

    Thanks, for ideas/help, on this.
  2. Stijnson

    Stijnson Registered Member

    Nov 7, 2007
    Paranoia Heaven
    Perhaps you should set the scan to 'scan and clean'? My guess is that you will get a message about found threats then.
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.