S.Blaster help D/L-ing updates

Discussion in 'SpywareBlaster & Other Forum' started by rastapasta, Nov 9, 2003.

Thread Status:
Not open for further replies.
  1. rastapasta

    rastapasta Registered Member

    Nov 9, 2003
    Hello----1st of all, I am not a newbie to this, & I was needing some help D/L -ing the new definitions. I was using S.Blaster just fine before I had to erase & reformat my hard drive & reinstall XP O/S, & now I can get S.Blaster to run, but when I try D/L--ing the new definitions, it shows the 2 available def. databases to be D/L-ed, & I click them to be D/L-ed, & then it says they've been D/L-ed successfully, & I hit "OK", then go to the screen showing all the definitions (next to checkboxes), & there should be the new ones highlighted in red, unchecked,right? Well, there's no new definitions shown, even after it says they've been D/L-ed successfully. Any info. on this? Thanx a bunch. --Also, I've tried this with my A/V & F/W disabled & running. Thanx
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.