"Run executable" feature results in "Custom action is in progress, reboot disabled"

Discussion in 'Other Acronis Products' started by heyyall, Jun 18, 2008.

Thread Status:
Not open for further replies.
  1. heyyall

    heyyall Registered Member

    Joined:
    Jun 18, 2008
    Posts:
    1
    I am testing SnapDeploy 3 in a school with 600 computers.

    I have set the template to run an executable after deployment. The executable I selected is a batch file. When deploying an image I get this message on the PC - "Custom action is in progress, reboot disabled". It waits for me to click OK, then I have to reboot the system before I can log into the domain.

    This prompt renders the feature useless for me since I cannot be bothered to click OK for so many computers. Is there any way around this? Thanks!
     
  2. ksr0108

    ksr0108 Registered Member

    Joined:
    May 22, 2008
    Posts:
    5
    Location:
    The Netherlands
    I had the same problem. So now I use Microsoft Sysprep and not the tools from the Acronis Template Wizard (I leave it blank).
     
Thread Status:
Not open for further replies.