ROger WIlco error help!

Discussion in 'ProcessGuard' started by Kegel, Jul 5, 2004.

Thread Status:
Not open for further replies.
  1. Kegel

    Kegel Registered Member

    Joined:
    Oct 28, 2003
    Posts:
    159
    5 Jul 23:13:33 - [HOOK] c:\program files\roger wilco\roger.exe [3036] was blocked from creating a global Low Level Mouse hook [0000000E][00000000]

    Is this something I should be worried about? It wont let me run Roger WIlco. Any way to get this to work? I get an error on lauch of RW that says unable to initialize direct input.....blah blah blah.
     
  2. Kegel

    Kegel Registered Member

    Joined:
    Oct 28, 2003
    Posts:
    159
    If I disable BLOCK GLOBAL HOOKS (or uncheck it) in the general protection options, it works. Any way to allow these "hooks" on a program by program basis?
     
  3. Gavin - DiamondCS

    Gavin - DiamondCS Former DCS Moderator

    Joined:
    Feb 10, 2002
    Posts:
    2,080
    Location:
    Perth, Western Australia
    Hi,

    If you block global hooks, you must allow trusted programs to create them - so add this program to the protected list and tick "allow global hooks"

    Or, dont block global hooks :)
     
  4. Kegel

    Kegel Registered Member

    Joined:
    Oct 28, 2003
    Posts:
    159

    OK Mr. Obvious. ;)

    Thanks for the reply....I didn't notice the Allow Global Hooks options there. Guess I should RTFM. ;)
     
Thread Status:
Not open for further replies.