Discussion in 'Trojan Defence Suite' started by marie, May 16, 2003.

Thread Status:
Not open for further replies.
  1. marie

    marie Guest


    I tried to update the radius from the site. (right click the file and over-write the existent one)
    But then, when i load the program, it still says my radius needs to be updated. I tried 2 or 3 times already.

    What should i do?

    thanx in advance
  2. LowWaterMark

    LowWaterMark Administrator

    Aug 10, 2002
    New England
    Hi Marie,

    When you run the evaluation version of TDS-3, it always reminds you to update the radius database even if you just loaded it. It is normal. Just make sure the version it is displaying is the new one that you've loaded, and you are all set. :cool:

    Best Wishes,
  3. marie

    marie Guest


    Thanx a lot for the quick answer!
  4. Jooske

    Jooske Registered Member

    Feb 12, 2002
    Netherlands, EU near the sea
    Hi Marie, welcome here!
    The radius is updated every workday mo-fr, at the site and the DCS forum on top (see link in my signature) you can always see the actual amount of references.
    Think this is a nice polite way to remind people about using an evaluation version. What you did, copy the radius in, start or reload TDS was correct.
    Once registered you can use the menu option which does all this for you automated: downloading the updated radius in the TDS directory, reloading the radius part --not all the startup scans and functions, only the radius and you're all uptodate. This updating can even be done automated if configurated.
    Hope you enjoy your software as much as i do. They've more nice tools to check out! Working fine side on side with it.
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.