PXE Booting across VLANs

Discussion in 'Other Acronis Products' started by bro969, Feb 19, 2009.

Thread Status:
Not open for further replies.
  1. bro969

    bro969 Registered Member

    Feb 19, 2009
    I currently have an issue whereby for any PC that is PXE booted from a different VLAN other than one particular PC the following error process happens:

    PC PXE boots from the NIC and gets a DHCP address then the following messages are displayed:

    PXE-T01: File not found
    PXE-E3B: TFTP Error - File not found
    PXE-M0F: Exiting Broadcom PXE ROM

    This error does not occur when PXE booting a PC located on the same VLAN.

    How best can I troubleshoot this, as i've got 3 different ip helper addresses and ip pim dense-mode configured?
  2. asan63

    asan63 Registered Member

    Feb 20, 2009
    PXE will not travel across VLANs. If you install PXE server on each VLAN it will work.
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.