PROBLEM: "unable to load resident protection"

Discussion in 'NOD32 version 2 Forum' started by septimus_bg, Jul 5, 2003.

Thread Status:
Not open for further replies.
  1. septimus_bg

    septimus_bg Registered Member

    Joined:
    Jul 5, 2003
    Posts:
    3
    When I stop AMON in CC and try to start AMON again, this message shows up...

    After restarting PC, AMON is STARTED?

    what do you think?

    NOD32 ver 2
     
    septimus_bg, Jul 5, 2003
    #1
  2. Meerschaum

    Meerschaum Guest

    It is a bug, it needs fixing.
     
    Meerschaum, Jul 5, 2003
    #2
  3. septimus_bg

    septimus_bg Registered Member

    Joined:
    Jul 5, 2003
    Posts:
    3
    So, it is well-known problem...OK
     
    septimus_bg, Jul 5, 2003
    #3
  4. anders

    anders Eset Staff Account

    Joined:
    Oct 25, 2002
    Posts:
    410
    Most often, you shouldn't have to disable the resident protection (no matter what the installation programs says :).

    However, during "heavy" file-operations and such, it might be.. "nice".

    Loading and unloading drivers can sometimes be troublesome, so the prefered and fast way is to disable the driver instead.

    To temporarily disable the resident protection, just deselect the checkbox "Resident module (AMON) enabled", and then select it again when you are done. But, in general, the resident protection should never have to be disabled.

    Best regards,
    Anders
     
    anders, Jul 6, 2003
    #4
  5. septimus_bg

    septimus_bg Registered Member

    Joined:
    Jul 5, 2003
    Posts:
    3
    OK, then, everything should be OK...

    p.s. you're very fast
     
    septimus_bg, Jul 6, 2003
    #5
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...