Phanth0m's Rules and specifically blocked ports

Discussion in 'LnS English Forum' started by jarrey, Sep 10, 2005.

Thread Status:
Not open for further replies.
  1. jarrey

    jarrey Registered Member

    Joined:
    Sep 10, 2005
    Posts:
    2
    I'm quite new to this and the writting rules are done differently then they are with sygate.

    In Phanth0m's Ruleset where would you look to see if these ports are already blocked?

    Port 135 (tcp/udp)
    Port 137 (udp)
    Port 138 (udp)
    Port 139 (tcp)
    Port 445 (tcp/udp)
    Port 593 (tcp)

    The only thing I could find in the forums on creating individual rules for port blocking is:

    "Well if you in reference to adding specific TCP/UDP ports without it being lined up in order like (4, 5, 6, 7, 8, 9), then you can configure up two ports per rule using “Equal Or” Feature in “Rule Editing” Dialog and in the “TCP/UDP: port” section."

    How would you go about creating a rule for a specific port, is there a section somewhere on how to do it that I'm not finding?

    TIA
     
  2. Thomas M

    Thomas M Registered Member

    Joined:
    Jan 12, 2003
    Posts:
    355
    I am not using Phantoms ruleset.

    You could try this link and ask over there:
    PhantOm's world

    Thomas :)
     
  3. CrazyM

    CrazyM Firewall Expert

    Joined:
    Feb 9, 2002
    Posts:
    2,428
    Location:
    BC, Canada
    Hi jarrey

    ... and welcome to Wilders :)

    If there are no rules permitting those services/ports, then they should be blocked by the Deny All Other rules for TCP/UDP. You should not have to create block rules for them.

    Regards,

    CrazyM
     
  4. jarrey

    jarrey Registered Member

    Joined:
    Sep 10, 2005
    Posts:
    2
    Thank you both CrazyM and Thomas M.
     
Thread Status:
Not open for further replies.