PG V3.4B1- Bug in Secure Message Handling

Discussion in 'ProcessGuard' started by siliconman01, Jun 14, 2006.

Thread Status:
Not open for further replies.
  1. siliconman01

    siliconman01 Registered Member

    Mar 6, 2003
    West Virginia (USA)
    Having SHM on ProcessGuard GUI is messed up again. The following sequence caused a failure.

    1. Open the PG GUI.
    2. Disable Protection.
    3. Click on the X to close the GUI
    4. Enter the SHM code
    5. After closure of the GUI, right click on the red Xed icon in the systray.

    The right click menu was totally blank. The GUI tried to open but could not. PG GUI using 92-100% CPU time. Could not get out of it. Used Ctrl-Alt-Delete for task manager initiated system shutdown/reboot.
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.