Paragon 2013 Recovery CD bug

Discussion in 'Other Paragon Disk Utilities' started by Trespasser, Jul 20, 2013.

Thread Status:
Not open for further replies.
  1. Trespasser

    Trespasser Registered Member

    Joined:
    Mar 1, 2005
    Posts:
    1,204
    Location:
    Virginia - Appalachian Mtns
    Hi,
    Yesterday I installed Paragon Free 2013. I created a Recovery CD then booted with it in my DVD drive. At the Backup and Restore interface I clicked on Hard Disk>Create Backup using CD/DVD (I not certain about the exact wording). I chose Best compression. It said I had 9.8 gigs to burn to a DVD disc. It burned the first disc, stopped, then asked to insert a blank disc and label it CD-2. I inserted another blank DVD disc and clicked OK. Very shortly after it showed a message saying the user had terminated the process and it did not proceed any further. I rebooted and tried it once again. It burned the first disc then the very same user terminated message showed once again.

    I hope I explained it well enough for you to understand what happened.

    This all occurred on an HP 2.0 ghz dual-core laptop with 4 gigs of ram running Windows 8.1 64 bit.

    Thank you.

    Best regards,

    Bob
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.