Nod32 3.0 Install Error - Urgent Help Needed!!!

Discussion in 'ESET NOD32 Antivirus' started by creapure, Nov 7, 2007.

Thread Status:
Not open for further replies.
  1. creapure

    creapure Registered Member

    Joined:
    Nov 7, 2007
    Posts:
    13
    Hi Guys,

    I tried to update nod32 2.7 to 3.0 but received an error message, so I uninstalled 2.7 and tried installing 3.0 but I still get the same message:

    Could not write value ConfigPath to key \System\CurrentControlSet\Services* \EhttpSrv\Parameters. Verify that you have sufficient access to that key, or contact your support personnel.

    And now I can't even re-install 2.7 back on.

    Could someone please please please help cause I have no idea what's going on and no anti-virus on :'(

    Thanks heaps!

    Crea
     
  2. creapure

    creapure Registered Member

    Joined:
    Nov 7, 2007
    Posts:
    13
    I have also restarted my computer after un-install, turned off my Outpost firewall and even used CCleaner, but no luck.

    Any help would be greatly appreciated. Thanks!

    Cheers

    Crea
     
  3. davstar

    davstar Registered Member

    Joined:
    Nov 7, 2007
    Posts:
    21
  4. ASM

    ASM Registered Member

    Joined:
    Jan 12, 2005
    Posts:
    164
    Same to me, I turned off Outpost FW... no luck too. You are not alone.:'(
     
  5. larryb52

    larryb52 Registered Member

    Joined:
    Feb 16, 2006
    Posts:
    1,126
    have you tried unloading outpost, I think nod needs to be installed 1st, than the firewall, I think it's protecting the registry...
     
  6. creapure

    creapure Registered Member

    Joined:
    Nov 7, 2007
    Posts:
    13
    OK guys, finally fixed it.... thanks to larryb52.... Here is what I did:

    1) Uninstalled firewall (in my case Outpost Pro).
    2) Used CCleaner for registry.
    3) Installed Nod32 v3.0.
    4) Installed my firewall (Outpost Pro).

    Worked like a charm!

    Hope this helps!!!

    Cheers

    Crea :D

    P.S: Thanks to everyone who tried to help! :D :thumb:
     
  7. ASM

    ASM Registered Member

    Joined:
    Jan 12, 2005
    Posts:
    164
    Hi guys... Thanks. It works.
     
Thread Status:
Not open for further replies.