new system drive installed trueiamge 9 not working

Discussion in 'Acronis True Image Product Line' started by stevengirdham, Dec 29, 2005.

Thread Status:
Not open for further replies.
  1. stevengirdham

    stevengirdham Registered Member

    Joined:
    Sep 26, 2004
    Posts:
    3
    i just cloned my c drive with trueimage 9 then in stalled the drive boot pc comes up with a ero message no NTLDR what is this. if i re start my pc and press f8 and pick out the new drive from a list of drives it then starts ok but i have to do this every time i boot up
     
  2. wonay

    wonay Registered Member

    Joined:
    Dec 29, 2005
    Posts:
    4
    2 possibilities:

    1. Make sure your boot.ini is correct.
    2. use Mbrfix to fix the mbr on the new drive.
     
  3. stevengirdham

    stevengirdham Registered Member

    Joined:
    Sep 26, 2004
    Posts:
    3
    how do you use Mbrfix
     
  4. Menorcaman

    Menorcaman Retired Moderator

    Joined:
    Aug 19, 2004
    Posts:
    4,661
    Location:
    Menorca (Balearic Islands) Spain
    Either boot from your Windows XP installation CD into the Windows Recovery Console and issue the command fixmbr or download the MBRautowrite file (CD ISO or self extracting boot floppy version) as detailed in the Acronis Support sticky titled <Please Read Before You Post>.

    Regards
     
  5. wonay

    wonay Registered Member

    Joined:
    Dec 29, 2005
    Posts:
    4
    You should take a look at BartPE which you boot your system into PE environment and then run mbrfix against your new hard drive.
     
Thread Status:
Not open for further replies.