Invalid Operation Code on restore

Discussion in 'Paragon Drive Backup Product Line' started by TugboatBill, Jan 6, 2012.

Thread Status:
Not open for further replies.
  1. TugboatBill

    TugboatBill Registered Member

    Jan 6, 2012
    I'm using the USB Recovery Media created by Backup & Recovery 2012 Free.

    Installed Win 7 x64 Pro on a PC with an Intel SSD. This created a basic GPT SSD with 2 partitions. This disk was then backed up to a NAS using the USB Recovery Media.

    I have another PC with a Intel SSD (same model/size). This SSD had an Win7 install, but with 3 partitions (has an UEFI MB). I attempted to do a restore hard disk using the USB Recovery Media but when it starts the restore I get an error box with "Invalid operation code". So I then deleted the partitions on that SSD (Partition -> Delete Partition). Tried the restore hard disk again and I get the same error.

    FWIW, If I remove the original SSD and put it in the destination system it boots fine.

    This is my 1st attempt with Paragon Backup & Recovery. :(
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.