installation command line switches

Discussion in 'NOD32 version 2 Forum' started by Kevin, Jul 14, 2003.

Thread Status:
Not open for further replies.
  1. Kevin

    Kevin Registered Member

    Joined:
    Oct 31, 2002
    Posts:
    28
    Hi all,
    I'm trying to install standard nod32 V2.0 to a group of workstations which will access the mirror I have set up on the server. Currently, I install the client version on the workstation, reboot, point it to the mirror and update. I'd like it to install with the mirror config without the extra steps. Version 1 had this capability using switches run from the setup.exe file but I haven't been able to figure out how to do it in version 2. Please advise.

    Kevin
     
  2. Kevin

    Kevin Registered Member

    Joined:
    Oct 31, 2002
    Posts:
    28
    Answered my own question. The example in the help files for Mirror\command line parameters is slightly incorrect. The switches in the example apparently must be upper case. Lower case doesn't function properly.

    Thanks anyway,

    Kevin
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.