Inserting licence no. for Bartpe/Acronis

Discussion in 'backup, imaging & disk mgmt' started by djg05, Jul 21, 2011.

Thread Status:
Not open for further replies.
  1. djg05

    djg05 Registered Member

    Joined:
    Apr 6, 2005
    Posts:
    1,565
    I am trying to make a BartPe boot disk for ATI ver 9. I am using the plugin supplied with Acronis and putting it in the BartPe plugin folder. The plugin is recognised and it will load ATI but stops because there is no licence number.

    I am not sure where this number should be placed. I am assuming in the inf file in BartPe and if so what syntax should I use.

    Would appreciate any help on this please.
     
    djg05, Jul 21, 2011
    #1
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...