ICH9 SATA controller

Discussion in 'other software & services' started by Lawrencem, Jul 21, 2008.

Thread Status:
Not open for further replies.
  1. Lawrencem

    Lawrencem Registered Member

    Joined:
    Jul 21, 2008
    Posts:
    1
    Hi Gurus,

    I just purchased a DELL VOSTRO 200 PC with the following specs:
    Intel(R) Core(TM)Duo CPU
    E4400@2.00GHz
    1.99GHz,0.99GB of RAM
    2GB Memory,80GB SATA HD,INTEL 945G Chipset.It has
    IDE Controller Intel(R) ICH9 2 port Serial ATA Storage Controller 2 - 2926
    IDE Controller Intel(R) ICH9 4 port Serial ATA Storage Controller 1 - 2920
    DISK DRIVE : WDC WD800JD-75MSA3

    My problem is that i am unable to install FEDORA CORE 5 which is what i need because i get an error in the very pre installation stages that ''No driver found-unable to find any devices of the type needed for this inatallation type.Would youlike to manually select your driver or use a driver disk?"

    Anyway to go around this?

    Will appreciate your contribution.
    Lawrencem
     
  2. Arup

    Arup Guest

    Ideally if your hdd is attached to SATA 0 you should not have any problems as the Fedora disc detects all SATA peripherals.
     
  3. lodore

    lodore Registered Member

    Joined:
    Jun 22, 2006
    Posts:
    9,065
    any reason for using fedora core 5?
    btw did you manually select a driver?
     
    Last edited: Jul 21, 2008
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.