Error Message Running SpywareGuard

Discussion in 'SpywareBlaster & Other Forum' started by Ken, Jul 3, 2003.

Thread Status:
Not open for further replies.
  1. Ken

    Ken Registered Member

    Joined:
    Jul 2, 2003
    Posts:
    3
    I'm running Windows NT. When I start SpywareGuard for the first time or reboot my computer, it runs for about a minute and I get the following error message:

    Run-time error '453':
    Can't find DLL entry point create Toolhelp32 snapshot in Kernel32

    Then I get a message that the program had failed and then SpywareGuard shuts down. The program will not start after this unless I reboot and the whole process starts over again. Can anyone tell me what is going on and how I can fix it?
     
  2. db

    db Guest

    I'm getting the same error using NT4.0 workstation with SP6. After the error it will shut down and if I go into the task manager and close the sgbhp.exe service I can run it again but only for a minute and then it errors again.

    Any suggestions.
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.