Error loading operating system

Discussion in 'Acronis True Image Product Line' started by fampuero, Nov 16, 2006.

Thread Status:
Not open for further replies.
  1. fampuero

    fampuero Registered Member

    Nov 16, 2006
    hi guys here is the scenario

    Samsung 80 SATA to Samsung 120 Sata...

    Using manual settings with the program, all seems to go well with the cloning but when i connect the new clone drive i get the ERROR LOADING operatin sytem...

    WIth a PATA Drive i usually use FDISK and make the partition active, but with SATA¿o_Oo_Oo_Oo_O

    Help... i see the data is in the new clone disk but cant boot from it..

  2. nughaud

    nughaud Registered Member

    Apr 19, 2003
    You can use the Windows CD and boot to it. Select any raid drivers to install using F6 and then go to the recovery console.

    Once at the console run the command: bootcfg /list

    It should list your Window Installation.

    Then you can run: bootcfg /add

    Select: 1 for the Windows Install.

    Then you can name the Windows Install like... Windows XP w/SP2 < as an example.

    Then you can pass any parameters, like /fastdetect

    Finish it and then reboot... you should see 2 operating systems to boot from and just select the operating system name you gave above... ex: 'Windows XP w/SP2

    From my experience this has seemed to fix the problem on 'like' systems.

    Hope this works, good luck.
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.