Enable/Disable SG using icon

Discussion in 'SpywareBlaster & Other Forum' started by LadyLuck, Jul 14, 2003.

Thread Status:
Not open for further replies.
  1. LadyLuck

    LadyLuck Registered Member

    Joined:
    Jun 29, 2003
    Posts:
    11
    I read the help topics for SpywareGuard. To enable/disable it says to double click the icon. When I did this the SpywareGuard came up but I don't see anything related to E/D. How can I tell if it's enabled? Sorry if this question sounds dumb, but I just downloaded it and learning.
     
  2. javacool

    javacool BrightFort Moderator

    Joined:
    Feb 10, 2002
    Posts:
    4,099
    After the main SpywareGuard window shows up, you should be able to see the status (i.e. if a green checkmark appears next to "Real-time Scanning Engine" then the main protection portion of SpywareGuard is enabled - the tray icon, the little red "SG", also will reflect if protection is disabled ... it will become a grey SG with an X over it).

    To enable/disable the protection, simply press the "Options" button on the main screen. There you will see various settings. Check any components to enable them, uncheck components to disable them (and press the "Save Settings" button).

    Best regards,

    -Javacool
     
  3. LadyLuck

    LadyLuck Registered Member

    Joined:
    Jun 29, 2003
    Posts:
    11
    Javacool, Thank you for your response.
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.