DirectX9 updating

Discussion in 'ProcessGuard' started by northstar51, May 12, 2004.

Thread Status:
Not open for further replies.
  1. northstar51

    northstar51 Registered Member

    Joined:
    Feb 5, 2004
    Posts:
    49
    hello: i am wondering how i should update my directX with PG running? should i shut down PG while installing the dx9 upgrade? do i need to do anything at all? is it ok to use the default PG settings for my directX? as usual, thanks in advance for the input...ns51
     
  2. Pilli

    Pilli Registered Member

    Joined:
    Feb 13, 2002
    Posts:
    6,217
    Location:
    Hampshire UK
    Hi Northstar51, I usually download the update then disable Process Guard for major updates.

    If you download the update or run it from CD then you could also disconnect from the Internet then disable PG. Remember to re-enable after the re-boot ;)

    Usually with winupdate the actual install takes place on reboot so it probably would not matter if PG was running but you may then get a few Secure desktop warnings of changed .exe's.

    No problems here when I updated to DirectX 9
     
  3. northstar51

    northstar51 Registered Member

    Joined:
    Feb 5, 2004
    Posts:
    49
    thanks as usual for your input...ns51
     
  4. northstar51

    northstar51 Registered Member

    Joined:
    Feb 5, 2004
    Posts:
    49
    :D hello: yes uninstall/reinstall did the trick. thanks ns51
     
Thread Status:
Not open for further replies.