Create partition correct aligned

Discussion in 'Paragon Partition Manager Product Line' started by LudwigFischer, Jun 13, 2010.

Thread Status:
Not open for further replies.
  1. LudwigFischer

    LudwigFischer Registered Member

    Jun 4, 2010
    I will create partitions, that are correct aligned from the begining
    1.) With PartMgr 11 Prof, I created pri+ext partitions
    2.) Restore from ext disc the system and data partitions
    3.) Run from system the partition align tool 2.0

    Is it possible from PartMgr 11 Prof to use an offset to create well aligned
    Its always created with offset 31kB

    I want to ask for an option offset inside the PartMgr,
    so I need not always run the part-align-tool after
  2. Paragon_Tommy

    Paragon_Tommy Paragon Moderator

    Aug 10, 2009
    If you are restoring an image onto an existing partition that you've created with PM 11, even though it's aligned, the restored partition may not. Restoration deletes the previous partition and restores your image with the old offset.

    I would recommend breaking down into two steps rather than combining. Restore the image, and if it's not aligned, use the alignment tool.
  3. superdoug3

    superdoug3 Registered Member

    Jun 27, 2009
    I am not sure when I need Partition Alignment tool.
    1. if I am using a single SSD - seems like it will be needed
    2. if I am using RAID0 on an HDD - seems like it will be needed

    current system
    WD HDD - black
    SSD - Vertex - 40 GB
    Vista Home Premium 32 bit
    Intel I7 920
    MSi motherboard
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.