Cloned SSD Won't Boot Snapshots/Imported Archives

Discussion in 'FirstDefense-ISR Forum' started by mrduke, Sep 11, 2014.

  1. mrduke

    mrduke Registered Member

    Joined:
    Sep 14, 2007
    Posts:
    9
    Windows 8.x

    I installed a Samsung SSD into my PC. Cloned my old HD using Samsungs software. I have found that now I cannot boot into any of the snapshots cloned over from the old HD and also cannot boot into any imported archive that was made on old HD.

    I am able to boot into snapshot that was active when cloning was done, and any snapshot created since then. When I have FD boot into a different snapshot, it will only boot into the one of the snapshots found on old HD, not the snapshot I select. If old HD is disconnected, the only boot that succeeds is the active one from SSD. I have tried using repair procedures on Windows disc with old HD disconnected, but that failed also.

    Any suggestions?

    Thank you,
    Duke
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.