capsa Alarm configuration

Discussion in 'Capsa Network Analyzer' started by kashan, Jan 11, 2013.

Thread Status:
Not open for further replies.
  1. kashan

    kashan Registered Member

    Joined:
    Jan 11, 2013
    Posts:
    1
    Location:
    pakistan
    Hi

    i have capsa 7 with 90 plus user,s i wnat to monitor Broadcast traffic Via Alarm pop up
    whenever any Broadcast is created it will alarm me
    how i can do this task!!!
     
  2. Colasoft Support

    Colasoft Support Colasoft Moderator

    Joined:
    Dec 6, 2007
    Posts:
    254
    Hi Kkashan,

    Indeed you can create alarms to monitor broadcast traffic, here is an example:

    1. right-click on FF:FF:FF:FF:FF:FF node under Physical Explorer/Broadcast Addresses on Node Explorer, select Make Alarm...

    1-select-broadcast-node.png

    2. Finish the settings per your requirements, such as: send an alarm when packets count reaches 10, every 5 seconds. If you enabled email notification, you can even get an email notification when the alarm is triggered.

    2-create-alarm.png

    3. You can then go to Node Explorer again, and repeat on the IP Explorer/Broadcast Addresses/255.255.255.255 to create an alarm to watch broadcast packets on IP layer. Hope this helps.
     
Thread Status:
Not open for further replies.