Acronis Snap Deploy 3 help

Discussion in 'Other Acronis Products' started by Blade74, Feb 20, 2009.

Thread Status:
Not open for further replies.
  1. Blade74

    Blade74 Registered Member

    Joined:
    Feb 20, 2009
    Posts:
    1
    I am having trouble getting a syspreped PC to boot into the enabled PXE server on the PC running the Acronis Console and license server. Does anyone know the "Magic Steps" to get this going.

    I have a DHCP server and the PC is set to network boot before trying the HDD. The most I have gotton out of it was TFTP..... after it received a proper IP-address. The Documentation is very spotty and is not clear where certain things need to be installed. Any help will be greatly appreciated.
     
    Blade74, Feb 20, 2009
    #1
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...