Acronis Loader: No configuration file present

Discussion in 'Acronis True Image Product Line' started by wsfnuby, Mar 27, 2008.

Thread Status:
Not open for further replies.
  1. wsfnuby

    wsfnuby Registered Member

    Joined:
    Mar 27, 2008
    Posts:
    5
    Hallo!

    I am using Acronis True Image 11 Home. To prevent a crash of my new Medion MD 8833 Computer, i installed Acronis True Image.

    To make sure that all is right, i tested the Boot-CD created from Acronis True Image.

    When i started my computer from the Boot-CD the error "Acronis Loader: No configuration file present"
    was shown on the monitor.

    From google i came on this Forum where many other have the same problem.
    But i couldn't find a solution, really.

    To my knowledge lies the problem that the Boot-CD cannot find the SATA-Harddisk. But i am not sure. (It is a Western Digital WD5000AACS).

    I would be very thankful if anyone could help me.
     
  2. wsfnuby

    wsfnuby Registered Member

    Joined:
    Mar 27, 2008
    Posts:
    5
    I have really no idea! o_O

    Isn't there anyone who can help me?
     
  3. K0LO

    K0LO Registered Member

    Joined:
    Mar 9, 2006
    Posts:
    2,591
    Location:
    State College, Pennsylvania
    wsfnuby:

    Try some of the suggestions listed under item II in this post from Acronis support.
     
  4. wsfnuby

    wsfnuby Registered Member

    Joined:
    Mar 27, 2008
    Posts:
    5
    Thanks for your email!

    Meanwhile i found the problem.

    I had to change the Bios-Setup.

    For the Hard-Disk, i had to change from AHCI to IDE.
    The settings were very hidden in the Bios.

    Then boot with the Acronis Boot-CD and make the image.

    After this you have to change the Bios settings again.
     
Thread Status:
Not open for further replies.