Acronis doesn't get any IP form DHCP (Snap Deploy)

Discussion in 'Other Acronis Products' started by Karsayor, Aug 8, 2007.

Thread Status:
Not open for further replies.
  1. Karsayor

    Karsayor Registered Member

    Joined:
    Aug 8, 2007
    Posts:
    1
    Hello everybody

    I created an Acronis Snap Deploy server, and configured DHCP and PXE server. It runs, but I have a problem.

    When I boot on PXE, Acronis starts, and I can launch Snap Deploy Console or Master Image Creator. But both of theses don't get any IP from DHCP. But my DHCP runs, because I receive an IP address when I boot on PXE...

    It's a little bit boring, because I always have to set an IP address manually.. :(

    Please help !

    (I Use Acronis Snap Deploy 2.0, and the DHCP Server is the one which is integrated with Windows 2003 Server)
     
  2. jsanders

    jsanders Registered Member

    Joined:
    Feb 1, 2008
    Posts:
    1
    Acronis Tech Support,
    Can you answer this questiono_O? I'm having the same issue with my setup. The machine get's an IP, boots via PXE and then when the client finally loads all I have is a 169 auto configured IP in my stack. Help
     
  3. tchoum

    tchoum Registered Member

    Joined:
    Feb 15, 2008
    Posts:
    1
    i had the same problem but i found a workaround :
    add the dhcp option number 67 : load file at boot (it's in your dhcp config mmc)
    the path is something like :
    "c:\program files\common files\acronis\pxe server\bootwiz.sys"

    ;)
     
Thread Status:
Not open for further replies.