Snap Deploy client keeps rebooting

Discussion in 'Other Acronis Products' started by Scootel2, Apr 15, 2008.

Thread Status:
Not open for further replies.
  1. Scootel2
    Offline

    Scootel2 Registered Member

    I have had great success with Snap Deploy v2 other then these few computers that share the same motherboard. What happens is I can see the Acronis logo in the top left corner right before everything is suppose to load the cursor blinks in the middle of the screen for 1-2 seconds and then the machine reboots. I have the latest edition of Snap Deploy (2152). If anyone can help me solve this problem I will greatly appreciate it. I have already tried the acpi=off noapci suggestion as well. If its any help these boards use the VIA VT6102 Rhine II NIC. Here are the last few lines of the log:

    03:00 rw=o, want=0, limit=40146624
    md: disabled device ide/host0/bus0/target0/lun0/disc, could not read superblock.
    md: could not read ide/host0/bus0/target0/lun0/disc's sb, not importing!
    md: autorun ...
    md: ... autorun DONE.
    $ /bin/rm -rf /etc/codepage /etc/pcmcia
    $ /bin/sh

    Thanks
Thread Status:
Not open for further replies.