Newbie question - seting UDP and TCP ports

Discussion in 'Colasoft Free Network Tools' started by george_vandelet, Nov 16, 2010.

Thread Status:
Not open for further replies.
  1. george_vandelet

    george_vandelet Registered Member

    Joined:
    Nov 16, 2010
    Posts:
    1
    Can someone please help me. I can not seem to find a way to modify for UDP or TCP packets the dst or src ports. Are they always zero?

    thanks

    George
     
  2. Colasoft Support

    Colasoft Support Colasoft Moderator

    Joined:
    Dec 6, 2007
    Posts:
    255
    Hi George,

    Are you talking about Packet Builder?

    If you cannot change the port number in Decode Editor, you can directly input port number under Hex Editor:

    Highlight the Source Port item in Decode Editor, and you will see the hex digits are highlighted too in Hex Editor.
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.