how can i restore an image?

Hi All,

i just used Drive Backup to create an image of my hard drive on my office server. I need to replace my hard drive in my PC. once i replace the hard drive....how can i restore the image to the new hard drive?

Thanks
cadman

 

To restore backup to new HDD you need to:
1) Create Paragon Recovery CD:
* go to Tools - Recovery Media Builder and follow the wizard to burn Recovery CD
2) Boot from Recovery CD and do the following:
* select Normal Mode
* run Restore wizard
* navigate to the archive location
(note: external/internal drive. where backup is stored should be connected before booting from Recovery CD)
* Select entire HDD backup, which should be displayed as Basic Hard Disk in archives info
* set destination - your new hard drive
* enable 'Resize proportionally' option
* apply operation

 

Thanks, Mech An...

i keep getting error 0x122e.
i think that means bad clusters...i ran chkdsk with no problems but i'm still getting the same error. Any suggestions on how to solve this?

cadman

 

Could you please specify when did you get the error?
Is there any description available?

Did you use CHKDSK /r ?