dcsmutex.exe changed?

Discussion in 'ProcessGuard' started by beethoven, May 28, 2005.

Thread Status:
Not open for further replies.
  1. beethoven

    beethoven Registered Member

    Joined:
    Dec 27, 2004
    Posts:
    1,391
    I am running TDS 3 and ProcessGuard. I only installed PG yesterday on this PC and since then have gone through the learning phase with several subsequent reboots. Some other programs have been upgraded without problems earlier today (ad-aware). Just now when I had another reboot and then manually started TDS3, I got an alert by PG that dcsmutex.exe has changed.
    Any idea why this file has changed? TDS has not been upgraded apart from the daily definitions :doubt: Obviously denying this file means that no mutex scan is being done.
     
    beethoven, May 28, 2005
    #1
  2. puff-m-d

    puff-m-d Registered Member

    Joined:
    Feb 13, 2002
    Posts:
    5,703
    Location:
    North Carolina, USA
    The mutexes most often change with the radius updates. This is normal if it occurs after an update and is nothing to worry about.
     
    puff-m-d, May 28, 2005
    #2
  3. beethoven

    beethoven Registered Member

    Joined:
    Dec 27, 2004
    Posts:
    1,391
    Thanks Kent for this superfast response :D :D
     
    beethoven, May 28, 2005
    #3
  4. puff-m-d

    puff-m-d Registered Member

    Joined:
    Feb 13, 2002
    Posts:
    5,703
    Location:
    North Carolina, USA
    No problem at all ;) ...
     
    puff-m-d, May 28, 2005
    #4
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...