WinPE recovery DVD hands up on boot

Hi All,

After few days of trial and erros I have realized that WinPE Recovery CD hangs up on start up because the SATA controller is set in AHCI mode and because another driver for the JMB362 eSATA controller is missing.

Can anybody tell me if it is possible to make a WinPE Bootable CD with this missing drivers? Ar at least with the AHCI mode enabled?
Is there any other workable solution?

Thanks

 

You'd have to rebuild the WinPE CD using the Windows Automated Installation Kit (WAIK)

http://www.microsoft.com/downloads/...6D-15F3-4284-9123-679830D629F2&displaylang=en

It's a little more difficult than the BartPE method, so I suggest using the BartPE method first.