Windows doesn't load after using Migrate Easy

Discussion in 'Other Acronis Products' started by TiNiB, Dec 22, 2006.

Thread Status:
Not open for further replies.
  1. TiNiB

    TiNiB Registered Member

    Joined:
    Dec 22, 2006
    Posts:
    1
    Hi I'm using the trial version of MigrateEasy. After having cloned my hard drive i swap the drives round with the newly cloned drive as master. After restarting I get the windows boot screen then get the windows xp logon screen and this is the screen it freezing on.

    Any ideas?
     
    TiNiB, Dec 22, 2006
    #1
  2. zempa

    zempa Registered Member

    Joined:
    Dec 27, 2006
    Posts:
    1
    Hi, Im having the same problem i think!

    Windows XP Pro tries too boot but the shutdownsound is looping.

    I have 2x 250 Sata 300 Raid 0 (intel Raid controller on a MSI P965 Platinum Motherboard").
    All the drivers needed are installed before the migrate were done!
    The only diffrens is faster disks...

    Best regards
    Johan Svensson
    Sweden
     
    zempa, Dec 27, 2006
    #2
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...