universal restore will not insatll

Discussion in 'Acronis True Image Product Line' started by Andyspencer, Aug 14, 2007.

Thread Status:
Not open for further replies.
  1. Andyspencer

    Andyspencer Registered Member

    Aug 14, 2007

    I have just downloaded and installed true Image server 9.1 build 3920. After installing this and rebooting the server the build shows as 3567. It will not then allow me to install universal restore as it says it needs build 3920.

    I have unistalled it twice and reinstalled off both the product download and the update download but the build number does not change

    Any help would be appreciated

  2. DwnNdrty

    DwnNdrty Registered Member

    Mar 28, 2007
    Florida - USA
    Sounds like you will have to manually remove all True Image and Acronis entries from the Registry then reinstall your 3920 build. Have you cleaned out all Cookies and emptied the Temp and Temporary Internet folders?
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.