True Image Loader does not start

Discussion in 'Acronis True Image Product Line' started by docnemo, Sep 23, 2007.

Thread Status:
Not open for further replies.
  1. docnemo

    docnemo Registered Member

    Sep 23, 2007
    after having upgraded my system (from Pentium 4 to Intel Dual Core 6750 with Gigabyte GA-P35-DD3/S3), True Image 10 Full Version doesn't load when booted from disk. The action simply stops without any message. In the secure mode, though, TI 10 works. When trying to boot from the TI 8 disk, I get the abort message: <hub.c connect-debounce failed, port 2 disabled>.
    Proir to the hardware upgrade, there were never any problems. Could the fault be in the BIOS settings? Does anyone have a clue?
    Doc Nemo
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.