spyware blaster 3.0

Discussion in 'SpywareBlaster & Other Forum' started by kbhgrh, Mar 30, 2004.

Thread Status:
Not open for further replies.
  1. kbhgrh

    kbhgrh Registered Member

    Joined:
    Mar 30, 2004
    Posts:
    2
    I installed spyware blaster 3.0 today & I get an error message that says "spyblaster caused a genetal protection fault in module <unknown> at 0000.0000058f." What do I need to do to be able to run spyware blaster
     
    kbhgrh, Mar 30, 2004
    #1
  2. LowWaterMark

    LowWaterMark Administrator

    Joined:
    Aug 10, 2002
    Posts:
    18,280
    Location:
    New England
    Hi kbhgrh,

    Take a look at the first page of posts in this section:

    http://www.wilderssecurity.com/index.php?board=34

    The ones marked as today will give you an idea of the issues being experienced by some people with the new install. This thread will be moved to that section a little later, as well, and hopefully someone will be able to advise you soon.

    Best Wishes.
     
    LowWaterMark, Mar 30, 2004
    #2
  3. Phant0m

    Phant0m Registered Member

    Joined:
    Jun 7, 2003
    Posts:
    3,726
    Location:
    Canada
    I don’t suppose it would help if you uninstall it and removing its cache-folder and closing out of mostly everything else before re-installing SpywareBlaster v3 then re-boot?

    btw What Windows ver you using?
     
    Phant0m, Mar 30, 2004
    #3
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...