Snapdeploy clients just reboot--not pulling an image

Discussion in 'Other Acronis Products' started by jcherpes, Jul 3, 2007.

Thread Status:
Not open for further replies.
  1. jcherpes

    jcherpes Registered Member

    Joined:
    Jun 27, 2007
    Posts:
    6
    I've been using snapdeploy for a little while and ,just recently, anytime I try to deploy more than a handful of systems about 75% of my clients reboot and no errors are produced in the log. I've got plenty of licenses, but nothing seems to work except just imaging one or two clients at a time. Has anyone else had this problem? And is there a way to fix this issue. I would say it happens anytime more than 3 systems are being imaged with either multicast or unicast.

    Hardware: HP DC7100

    Software Snapdeploy 2.0 build 2135
     
  2. TravisTMan

    TravisTMan Registered Member

    Joined:
    Mar 27, 2007
    Posts:
    7
    I had the same thing happening. I updated to the latest version and replaced my switch - problem went away.

    Travis
     
  3. maloneyr

    maloneyr Registered Member

    Joined:
    Aug 16, 2007
    Posts:
    1
    i had this issue and i resloved it by connecting them on the same switch so to cut out any network issues
     
Thread Status:
Not open for further replies.