Snap Deploy Server Slow on Dell 2650

Discussion in 'Other Acronis Products' started by chadd39, Feb 29, 2008.

Thread Status:
Not open for further replies.
  1. chadd39

    chadd39 Registered Member

    Feb 29, 2008
    I have 2 PE 2650's. I am using Snap Deploy 2.0. I made an image of server1 to a network location. It was 45GB and took about 45 minutes.. I then booted server2 with the bootable disk, went to the management console to deploy the image of server1 to server2. I then launched it. That was 2 hours ago. The console shows 9% and 43%. Is this a typical time? I have read several posts stating that snap deploy is slow. SHould it be this slow...??

    Both machines are identical. I was hoping to just spend a few hours imaging server 2 tonight, but at this rate, it will take about 12 hours.... Any ideaso_O Is this common?:oops:
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.