Snap Deploy - cannot assign manual IP address

Discussion in 'Other Acronis Products' started by leonthrilla, Aug 18, 2006.

Thread Status:
Not open for further replies.
  1. leonthrilla

    leonthrilla Registered Member

    Joined:
    Aug 18, 2006
    Posts:
    2
    Hi,

    I'm trying to boot snap deploy with manual IP,
    quiet if=eth0 ip=x.x.x.x mask=xxx.xxx.xxx.xxx , but agent still using ip from 169.x.x.x network.

    I've already boot without the quiet command, the boot image can recognize my ethernet card, and I can give an IP address manually from the command shell. so it's not related with my network card.

    can someone help me ?
     
    leonthrilla, Aug 18, 2006
    #1
  2. leonthrilla

    leonthrilla Registered Member

    Joined:
    Aug 18, 2006
    Posts:
    2
    sorry not snap deploy, I'm using acronis rescue media ...
     
    leonthrilla, Aug 18, 2006
    #2
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...