Settings (New User)

Discussion in 'ProcessGuard' started by JulesP3, May 30, 2005.

Thread Status:
Not open for further replies.
  1. JulesP3

    JulesP3 Registered Member

    Joined:
    May 30, 2005
    Posts:
    2
    I have just installed ProcessGuard and I would like advise on suggested and best general settings that would configure ProcessGuard to allow only those programs it currently has on file to start and alert me when any new application starts. I do not want implicit acceptance just because I opened an application manually. This is how my firewall operates and I would like the same type of behaviour for ProcessGuard.

    Any ideas?

    Thanks for considering this request.
     
  2. BlueZannetti

    BlueZannetti Administrator

    Joined:
    Oct 19, 2003
    Posts:
    6,590
    JulesP3,

    Once PG is out of learning mode, that is how it works. As I recall, the install session learning mode survives two additional restarts, after which learning mode is turned off unless it is actively enabled by the user.

    Blue
     
Thread Status:
Not open for further replies.