restricting outgoing (?) connection in CFP3

Discussion in 'other firewalls' started by _ab, Mar 30, 2008.

Thread Status:
Not open for further replies.
  1. _ab

    _ab Registered Member

    Joined:
    Aug 2, 2007
    Posts:
    74
    Hi,

    here is this defragger, that uses TCP port 50300 with remote port 0.0.0.0 (O&O Defrag), anyway, i´m using CFP3 (but this applies to all other firewalls as well) & it is set to "Allow IP Out From IP Any To IP Any Where Protocol Is Any".

    I tried to create a new rule, only allowing TCP to connect to port 50300 ( i dont´t know if i did it correctly), & deleted the old rule, but it keeps coming back (after that there where two rules then).

    Is this because the defragger is an "trusted application" or in the Comodo whitelist, or is it pointless anyway? I know that it´s most likely not going outbound, but i´d like to know. :)
     
  2. ggf31416

    ggf31416 Registered Member

    Joined:
    Aug 20, 2006
    Posts:
    314
    Location:
    Uruguay
    Set Security Level to Custom and Alert Level to High (Advanced -> Firewall Behavior Settings)
     
  3. _ab

    _ab Registered Member

    Joined:
    Aug 2, 2007
    Posts:
    74
    ok, i will try that. thx!
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.