ProcessGuard settings for Spyware Doctor

Discussion in 'ProcessGuard' started by frank4553, Jul 24, 2005.

Thread Status:
Not open for further replies.
  1. frank4553

    frank4553 Registered Member

    Joined:
    Sep 14, 2004
    Posts:
    25
    Hi All

    The following messages are popping up:
    swdoctor.exe tried to install a driver/service nmamed 'mchlmjDrv', and
    swdoctor.exe was blocked from terminating smss.exe

    So, which 'Global Protection Options' is it OK to allow for Spyware Doctor?

    Also, smss.exe has rights to 'read, modify and terminate' and install drivers and access physical memory....is this OK.

    Does anyone know of a list of PG settings to use with the range of security software generally in use....I know of the list on the DCS website, which is very good, but are there any others?

    Any help much appreciated.

    Regards

    Frank
     
  2. beetlejuice69

    beetlejuice69 Registered Member

    Joined:
    Mar 16, 2005
    Posts:
    780
    I have PG set up that way with smss and give Spyware Doctor the rights it needs. Everything works fine and they all seem to be happy. :)
     
  3. Peter2150

    Peter2150 Global Moderator

    Joined:
    Sep 20, 2003
    Posts:
    17,059
    Hi Frank

    A generalization. If you buy a program, one should assume you trust it. Just set it up in Learning Mode per the help file and you should be fine. Don't try to manually set up every new piece of software.

    Pete
     
  4. frank4553

    frank4553 Registered Member

    Joined:
    Sep 14, 2004
    Posts:
    25
    Thanks Beetlejuice and Peter.
    Sound advice....I'm probably being just a little bit paranoid!

    Thanks

    Frank
     
Thread Status:
Not open for further replies.