Paragon HD Manager Pro 2010 -- Logs and Mac

Discussion in 'Other Paragon Disk Utilities' started by ixthnar, Aug 14, 2010.

Thread Status:
Not open for further replies.
  1. ixthnar

    ixthnar Registered Member

    Aug 14, 2010
    I was using Paragon Harddisk Manager Pro 2010 to clone a 500Gb Mac OS X drive with a HPFS Mac partition and an NTFS Windows Bootcamp partition. The target drive is connected via an eSata adapter plugged into my MacBook Pro. When the clone was nearly complete and it was looking for a Windows install, an error appeared in the logging window. Before I could copy the information, to software rebooted the computer. The error message was just a number ... is there a log? Is there a way to interpret the error numbers?

    Oh yeah ... I had run CHKDSK /f before this operation. Just for good measure I ran it again after ... still running stage 5 but no problems so far.

    btw ... Paragon Harddisk Manager Pro 2010 says that it can clone Mac drives with Bootcamp (aka Boot Camp) partitions ... is this really the case or are they just hoping?

    Thanks, Chris
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.