Paragon 10 Prof. Restore doesn't work

Discussion in 'Paragon Partition Manager Product Line' started by JoeM55, Dec 27, 2009.

Thread Status:
Not open for further replies.
  1. JoeM55

    JoeM55 Registered Member

    Dec 27, 2009

    I save my XP Partition with Version 10 and now I will restore it on an second Harddisk.

    But only restore on the same harddisk works, restore on the second harddrive results with 25 % (format complete) - Thats all.

    Thanks for your help!

  2. Paragon_Tommy

    Paragon_Tommy Paragon Moderator

    Aug 10, 2009
    Hello JoeM55,

    Can you give us more information about how large the original hard drive is or the size of the partition you backed up. Are you restoring to a smaller hard drive?

    With the 2nd HDD attached to an operating system, run a check disk on the HDD for bad sectors.

    Start > Run > "cmd" > "chkdsk /r x:"

    X: being the letter of your 2nd HDD.

    You say it stopped at 25%. How far into the restore did it fail, time-approximately-wise. If you were able to restore to the original hard drive successfully, that tells us the archive is good and the destination hard drive is causing problems.
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.