New RAID array

Discussion in 'Acronis True Image Product Line' started by GreggC, Nov 23, 2006.

Thread Status:
Not open for further replies.
  1. GreggC

    GreggC Registered Member

    Joined:
    Nov 19, 2006
    Posts:
    7
    I am currently running two hdds in a RAID array. Is it possible to do a back-up using TI, install a third hdd, create a new 3 drive RAID array, and restore the back-up onto the new RAID array?
     
    GreggC, Nov 23, 2006
    #1
  2. jaycee

    jaycee Registered Member

    Joined:
    Aug 24, 2006
    Posts:
    186
    I would say yes, just make sure your RAID array is supported by Acronis Rescue Boot CD, else you'll need to go to BartPE.
     
    jaycee, Nov 23, 2006
    #2
  3. Acronis Support

    Acronis Support Acronis Support Staff

    Joined:
    Apr 28, 2004
    Posts:
    25,885
    Hello GreggC,

    Thank you for choosing Acronis Disk Backup Software.

    We are sorry for the delayed response.

    Yes, you will be able to perform this task with help of Acronis True Image.

    Depending on the operating system you use you will need different version of Acronis True Image. Please have a look at this previous post of mine for more information about supported operating systems.

    Please note that if you are going to replace the RAID controller as well, then it is recommended to use Acronis Universal Restore plug-in for Acronis True Image Corporate Product line.

    Thank you.
    --
    Aleksandr Isakov
     
    Acronis Support, Dec 19, 2006
    #3
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...