Need Help Please - Netscreen 25 with Fortigate 60.

Discussion in 'other firewalls' started by nileroy, Sep 15, 2005.

Thread Status:
Not open for further replies.
  1. nileroy

    nileroy Registered Member

    Joined:
    Sep 15, 2005
    Posts:
    1
    Location:
    Bombay, India
    Hi All.

    Good Morning & Greetings of the season.

    I recently joined this company as a Network Security Specialist & the 1st task that i got assigned to myself was this.

    We have 3 locations -
    A (India) - Indian Operations
    B (California) - US Operations
    C (Datacenter) - Web & Media Servers

    My network setup is as given below.

    I have 3 fortigate 60 with me. I have a site-to-site VPN setup on the 3 FG60 boxes.

    My 3 office internal networks are:
    Location A - 192.168.0.X/255.255.255.0
    Location C - 192.168.1.X/255.255.255.0
    Location B - 192.168.2.X/255.255.255.0

    I have been given one Netscreen 25 (baseline).

    At the Location C - Datacenter, the data flow path is as follows:

    ISP Switch - Fortigate - Our Switch - Servers

    Now, I need to install this netscreen 25 after the Fortigate in the sequence above.

    i.e., my setups should be:

    ISP Switch - Fortigate - Netscreen - Our Switch - Servers

    I know how to connect the cables, i mean which cable goes where.

    I need the Netscreen configuration for either Transparent Mode or Nat/Route Mode.

    I have been a total cisco & checkpoint guy so far & have never worked on netscreen earlier.


    Hence, I request from all you guys out here, to please suggest me & help me out.

    Best Regards,

    Nilesh Roy | +91 932 379 8440
     
Loading...
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.